All ideas

At several places a parameter is entered with a slider. Unfortunately this sometimes prohibits a precise setting of a value. So besides the slider (and clicking where fixed steps are added/subtracted), a simple entering of the value should be enab...

When entering new parameter values in the analysis Harmony automatically realculates the results. While this might make sense ... the UI is not capable of handling this properly. Any changes that one makes while the update-calculation happens are ...

Currently users can't determine from an Evaluation with a Maximum Projection, if all planes were used or not. And if not all planes were used: which ones were selected. And for fields, probably only if Object Results are selected the actually anal...

On the Evaluation tab the target temperature / CO2 values are displayed, and a flag if it was too low / in range / too high. Instead of the flag a display of the actual temperature / CO2 value would be better. Then the user can decide, if a deviat...

In a kinetic experiment in the beginning it might be not relevant that the desired temperature / CO2 is reached, a couple of ° or % above/below might be fine as well. Currently the users have only a tick mark or an arrow ... but no information wha...

Often analysis sequence are specific to a "project", or belong to a "customer" or whatever keyword one might have in Harmony. Unfortunately, those keywords are only available for Measurements. Therefore, it would be good if all the keywords would ...